cart Shopping Cart Shopping Cart
Acetyl injection moulded mini valve
larger imageMove mouse over the image to magnify
02067

Acetyl injection moulded mini valve

For inlet pressures up to 850 kPa (120 Psi)
NZ $32.18
Qty.
A compact design for use in small drinkers and for inlet pressures up to 850 kPa (120 Psi). It has two float positions to allow water level adjustment. The float is made from quality, light weight injection moulded plastic and an acetyl insert in the float creates a stronger thread. Made of non corrosive materials.
 

Key specifications

  • Minimum temperature: 1˚C and in areas where the temperature can be lower than 1°C (minimum service temperature) trough valves must be installed as bottom or side entry but NOT top entry.
  • Maximum temperature: 60˚C
  • Inlet pressures up to 850 kPa or 120 Psi
  • Length: 270mm overall including float
  • ½", ¾" long tail sizes

 

You might also be interested in ...

About Allflow

Allflow specialises in providing innovative, high quality pumping equipment and vacuum tanker products for industrial requirements that will exceed expectations.

Read more >

yt icon rgb wee
   
Contact Information
Phone: 03 543 9057
0800 255 356
Email: sales@allflow.co.nz
 
58 Gladstone Road
Richmond 7020
New Zealand