cart Shopping Cart Shopping Cart
Moro Kaiser PM 80AM
larger imageMove mouse over the image to magnify

Moro Kaiser PM 80AM

Moro Air Series Industrial Vacuum Pump - Made in Italy
NZ $4,840.00
MORO AIR Series Pumps are industrial duty vacuum pumps are made in Italy and are commonly used in septic, grease trap, commercial and agricultural applications.

The PM80AM pump is designed primarily for use on slurry/muck vacuum tankers in agricultural applications where the pump can be powered from a tractor PTO and run at 540rpm PTO speed..

These pumps feature high heat resistant Cast Iron Bodies, self-adjusting heat resistant Kevlar vanes, heat resistant Viton seals, built-in non-return valve, built-in vacuum/pressure changeover valve, positive lubrication supplied by a built-in gear pump and oil reservoir, and direction adjustable 3" inlet and outlet hose-tail elbows.

AIR FLOW: 12,000 L/min (10,000L @ 450rpm)
POWER REQUIRED (at max vacuum): 14kW (18.8hp)
MAX OPERATING PRESS: 2.5 bar (35psi - subject to vacuum tanker suitability)
PUMP SPEED: 540rpm max (450rpm recommended)
SHAFT: Standard 6 tooth PTO spline
PORTS: 3" Hose Tails - adjustable elbows.

The MORO range of Vacuum pumps are common in the Industrial Vacuum Truck market where demanding duties and high reliability are required day in/day out. All parts are available for all future servicing requirements.

 Moro PM80AM Flow Rate - Small
Check out our High Grade Vacuum Pump Oil - recommended for use in MORO Vacuum Pumps!!

TIP: Prolong the life of your vacuum pump by running the correct type of oil in it, to avoid the bore running dry under high vacuum. Under high vacuum and high temperatures as found in vacuum pumps, incorrect grades of oil can thin out and/or flash off leaving an insufficient oil film, thus causing any vacuum pump to run dry, accelerating vane and bore wear.
High Grade pump oil is designed to retain film thickness under high operating temperatures at the same time as high vacuum.  Correct High Grade Oil doesn't absorb moisture - critical to vacuum pumps on slurry tankers as they always draw in moisture with the incoming air that has been removed from the tanker.

Want to know more?  Call us TOLLFREE 0800 255 356

Click to watch this video clip

Moro Pumps, Italy

You might also be interested in ...

About Allflow

Allflow specialises in providing innovative, high quality pumping equipment and vacuum tanker products for industrial requirements that will exceed expectations.

Read more >
Contact Information
Phone: 03 543 9057
0800 255 356
58 Gladstone Road
Richmond 7020
New Zealand