Ideal for pumping clean or slightly dirty water, such as sump emptying, dewatering of cellars, garages, ditches and ponds or decorative water features.
Equipped with preset length float switch for automatic operation.
Open impeller, centrifugal design
Able to pump small soft solids in suspension
Less susceptible to blockage
Double mechanical shaft seal in oil bath with hard faced silicon carbide / ceramic seal on pump side
Sand slinger lip seal
Corrosive resistant 304 stainless steel motor shell and strainer
High quality paint finish
Automatic resetting thermal overload
Protected against overloading
HO7RNF oil resistant leads, 10 metres long with 3 pin power plug
Ideal for pumping clean or slightly dirty water, such as sump emptying, dewatering of cellars, garages, ditches and ponds or decorative water features.
Equipped with preset length float switch for automatic operation.Open impeller, centrifugal design
Double mechanical shaft seal in oil bath with hard faced silicon carbide / ceramic seal on pump side
Sand slinger lip seal
Corrosive resistant 304 stainless steel motor shell and strainer
High quality paint finish
Automatic resetting thermal overload
HO7RNF oil resistant leads, 10 metres long with 3 pin power plug
Materials of construction
Motor top: Cast iron
Pump body: Cast iron
Motor shell: 304 stainless steel
Strainer: 304 stainless steel
Impeller: Cast iron
Lip ring: Nitrile
Mechanical seal: Carbon/ceramic on motor side
Seal & bottom bearing housing: Cast iron
Handle: 304 stainless steel
Fasteners: 304 stainless steel
Float & power supply leads: H07RN-F oil resistant
Operating limits
Capacities: 200 lpm
Heads to: 9.5m
Maximum submergence: 10m
Maximum operating temperature: 50ºC